Permabond TA4204 1 x 50ml cartridge with mixing nozzle Expand

Permabond TA4204 Toughened Acrylic Adhesive 50 ML Plus Free Nozzle

Permabond Permabond


Permabond TA4204 Toughened Acrylic adhesive x 50 ml Cartridge

  • Adhesion to a wide variety of substrates
  • Fastcure at room temperature
  • Can be used with or without nozzle - supplied with 1 nozzle free of charge/cartridge
  • High shear and peel strength
  • Good impact strength
  • Good chemical resistance
  • Crystal clear appearance
  • Bonds well to unprepared aluminium
  • Also available in 400ml cartridge

Please refer to product data sheet for further information

More details


PERMABOND® TA4204 is a 2-part, 1:1 toughened acrylic adhesive. It can be used to bond a wide variety of materials including metals, plastics, GRP, ceramics, wood and other substrates.

It is
convenient to use in an easy-to-dispense cartridge or it can be used bead on bead without a mixing nozzle


Surface Preparation

Surfaces should be clean, dry and grease-free before applying the adhesive. Permabond Cleaner A is recommended for the degreasing of most surfaces. Some metals such as aluminium, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.


Directions for Use

1) Surfaces must be clean, dry and grease-free. If using a cleaning solvent, allow 3-4 minutes to fully evaporate before applying adhesive.
2) Apply a thin bead of adhesive pre-mixed through a static mixer nozzle. If no mixing nozzle is being used, make sure one component is extruded on top of each other (not side by side).
3) Alternatively apply a thin layer of resin on one component and hardener on the other.
4)Assemble components and clamp.
5)Maintain pressure until handling strength is achieved. The time required will vary according to the joint design and surfaces being bonded.
6)Allow 24 hours for adhesive to fully cure. Accelerated cure times may be achieved by heating.